EZ Handrail EZG106 Manual de Instruções descarregar pdf (Página 9)

Installation into concrete

STEP 1:

1. Turn the post upside down on a hard surface and prepare to drill

larger holes in base plate.

Enlarge the (4) existing post base plate holes to 5/16” (using a 5/16”

drill bit).

2. Determine the 3”x3” post location(s). Spacing between posts should

be 6’ or less to meet IBC codes when installed 24” or higher above

the ground.

3. We recommend the edge of the 5”x5” base plate is fastened at least

1 ½” in from the edge of any concrete face (assuming normal weight

concrete).

4. Square up the post with the concrete surface and mark all (4) holes

with a marker.

5. At your (4) marks, drill a 1/4” to 3 ½” or deeper hole into the

concrete using a masonry bit.

6. Fasten post in place with provided ¼” x 3” Powers Wedge Bolts

7. Begin tightening the anchor with socket wrench or impact wrench by

rotating clockwise and applying pressure in toward the concrete.

8. Continue tightening the anchor until the head is firmly seated against

the post base plate. (Do not over tighten).

9. Slide on optional post base cover to hide fasteners.

Attach post cap after railing has been installed using 1” fasteners

provided.

www.ezhandrail.com for videos 9

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 22 23

Sem comentários

EZ Handrail EZG106 Manual de Instruções Página 9